AVIRE Connex-02 Guia De Instalacion página 6

6. Switch Configuration Cases
Connex-02 comes preset as an end of line device (switch "4" configured as "on") as per
figure 1 below.
6.1 In a system with more than one lift car select the lift shaft for each Connex-02, using
configuration switch "1" and "2". The below table shows how to set the ID for each
Connex-02.
Fig 2**
6.2 Up to two devices can be installed per simplex lift installation. Select second
Connex-02 as 81 using switch "3".
Default
6.3 If Connex-02 is the End of Line (EoL) device, assign the device as EoL by switching
configuration switch "4" to ON. Otherwise, configuration switch "4" should be OFF.
Default
*e.g. fig. 1 is set to Lift 1, the device is installed in the Landing/Motor Room control cabinet and is the End of Line device.
**e.g. fig 2 is set to Lift 3, with the device installed at the top of car and is the End of Line device.
Default
Fig 1*
6