and fully.
•
When disposing of the installed battery, it must first be removed and then disposed
of separately from the Hoverboard. Please have the batteries replaced only by
qualified personnel. Please do not do this yourself. Please read again our section
5. Disposal.
•
Please do not open the housing of our Hoverboard in order to probably change the
battery yourself.
NOTES ON CHARGER SAFETY
•
The battery charger must not be used by children.
•
People with restricted physical, sensory or mental abilities must not use the
device. If there is insufficient experience and knowledge, it must not be used. The
person concerned must be supervised, and the correct handling of the equipment
and the risks involved must be understood.
•
Children are not allowed to play with the charger
•
Children must not clean or service the device. If the charger cable is defective, it
must be replaced by the manufacturer, a specialist dealer or another qualified
person. Otherwise there is danger.
•
After use, turn off the charger and disconnect it from the power supply. Please
allow it to cool down before you transport, clean or store it.
•
It is crucial to protect electrical parts from moisture. When cleaning the appliance,
or when it is in use, make sure that no liquid is dripping or flowing into the appliance.
Otherwise, you may suffer an electric shock. Do not keep the charger under water.
Refer to point 4.3 Storage of the Hoverboard and transport.
•
When you start the charging process, always ensure sufficient air supply. Gases
could form here.
•
When using the charger, be sure to periodically check for damage. You can only use
a defective charger again if it has been refurbished.
•
Do not use the charger if it has taken a hit or a knock: for example, when it fell or is
damaged for another reason.
•
If the device is defective, do not connect a charger. Otherwise you could suffer an
electric shock.
•
Do not disassemble the charger under any circumstances. Only experts or the
authorised technical customer service may be instructed with the repair. If the
assembly was faulty, this may cause an electric shock.
•
Do not use the charger near explosive or flammable objects. Otherwise, there is
risk of explosions and fire. Before you connect the device to the power supply, you
33