DJI RONIN-SC Guia De Inicio Rapido página 8

2. Balancing the vertical tilt
a. Rotate the tilt axis so that the camera lens is pointing
upward. Check to make sure the camera is not top or
bottom-heavy. If the camera is tilted to one side, pull the tilt
arm towards the other side.
b. Loosen the knob on the tilt motor
of the camera
or down.
c. Tighten the knob.
d. Repeat Step 1 to balance the depth of the tilt axis. The
slider on the dovetail plate is used to record the balance
position. Move the slider next to the mounting plate and
tighten the slider.
1
3. Balancing the roll axis
a. Lock the tilt axis and unlock the roll axis. Check the direction
in which the roll motor swings. If the camera rotates to the
left, move the camera to the right. If the camera rotates to
the right, move the camera to the left.
b. Loosen the knob on the camera mounting plate
adjust position of the plate
c. Tighten the knob. If the camera moves forward, move the
camera back until the slider is next to the mounting plate.
until the camera is steady without tilting up
2
until the camera is steady.
2
© 2019 DJI OSMO All Rights Reserved.
and adjust the balance
, and
1
7