Eaton Metalux SN LED Serie Instrucciones De Instalación página 3

Installation Instructions – SN LED Lens
INSTALLATION
1. Remove the lens from the incoming protective
material and set aside. Wire luminaire according
to code. (Figure 1.)
1. Secure one side of the lens to the luminaire by
sliding it along the channel cover until the lip
of the lens is located beneath each of the lens
clips. (Figure 2.)
2. Pivot the unsecured side of the lens toward
the channel cover and squeeze it slightly in the
areas where the lens clips are present, allowing
the lip to be located beneath the clip. (Figure 3.)
N ote: If luminaire is a high lumen package,
secure lens to the end with short LED
boards first.
3. Verify the lip of the lens is engaged in all (8)
eight clips per 4ft section.
4. Center the lens of the luminaire as needed.
(Figure 4.)
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Instructions d'installation - DEL SN
IB519098EN www.eaton.com
Installation Instructions – SN LED
3