Arm / Disarm; To Arm The Alarm System; Important - Toyota VSS3 Manual Del Propietário

2. Arm / Disarm

UNLOCK
(Disarm)
LOCK
(Arm)
The alarm system will be armed when you push on the alarm system lock button, and disarmed
when push on unlock button.

2.1. To ARM the alarm system

Important:

To prevent false alarm, check that there is no one in the car, and that all windows and sliding
roofs are closed before locking the car (see how to deactivate the interior intrusion sensor in
paragraph 2.4).
Action
Alarm system remote: Press
the lock button once.
Note:
– The car LED blinks (if applicable on your car) to inform you that the immobiliser is set (not
linked to alarm system)
– If any door is not securely closed, application depending on the car, 10 short beeps will sound
(car will not be locked, but alarm system will be armed) and the switch will be deactivated
until door is closed properly.
– The system will be armed 30 seconds after the lock button is pressed (pre-arm time).
– If your remote key is not working, you can arm the system by PIN code (see chapter 3.2).
Hazard light indication
Flashes once.
Alarm status light (LED)
ON for 30 seconds, then
starts flashing.
VSS3 9