Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CLEANING THE APPLIANCE
•
Detach the plug (4) from the recharging contact (8e).
•
switch the appliance off before cleaning it.
•
when necessary, clean the appliance with a damp cloth.
ATTENTION!
DO NOT USE SOLVENTS OR OTHER AGGRESSIVE OR ABRASIVE
DETERGENTS. THIS CAN DAMAGE THE SURFACE.
CLEANING THE DUST COLLECTION SYSTEM
ATTENTION! Empty the dust collection compartment (8B) and clean the
filtering system (8C, 8D) after every use.
•
clean the dust collection system following the instructions below and paying attention
to the figures in the illustrative guide.
•
Detach the mini-vacuum (8) from the body of the stick by pressing the release buttons
(5) [Fig. D1].
•
press the release button (8a) [Fig. e1] and take down the dust container (8b+8c+8D)
[Fig. e2].
•
take out the filtering system (8c and 8D) [Fig. e3] and empty out the contents of the
dust container (8b).
•
separate the filter protection mesh (8c) from the cyclone filter (8D), and clean them
by carefully shaking and brushing away the dust. to do so, use a soft brush to prevent
any damage.
if suction does not increase after cleaning the dust collection compartment (8b) and the
filtering system (8c+8D), replace filter 8D with a new one.
NOTE:
•
Replace the filter in the event it is damaged or impossible to clean.
•
Replace the filter at least once a year.
•
Failure to clean or replace the filter will make the manufacturer's warranty null
and void.
put the filtering system (8c+8D) back inside the dust compartment (8b) and reattach it to
the mini-vacuum (8), being careful to hook it onto the bottom fitting and making the release
button click (8a).
CLEANING THE TURBO BRUSH
•
Detach the turbo brush (7) from the suction inlet (6) by pressing the brush release
button (7a).
•
if the rotating brush (7c) is dirty with hair or fluff, remove the debris with a pair of
scissors, being careful not to cut yourself. [Fig. e4].
•
if the rotating brush (7c) is very dirty, it can be detached from the turbo brush (7).
•
to detach it, turn the clamping screw of the rotating brush anti-clockwise (7b) and lift
the rotating brush (7c).
14
Publicidad
Capítulos
Tabla de contenido
