Advanced Configuration; Connecting To The Smart-1 Appliances Cli - Check Point Smart-1 205 Guía De Introducción

Advanced Configuration

Advanced configuration on Gaia
Advanced configuration on Gaia can be done from the WebUI or the CLI.
Advanced configuration on SecurePlatform
Advanced configuration on SecurePlatform can be done with the sysconfig menu
from the CLI.
Note - The sysconfig menu is only available after running the First Time
Configuration Wizard in the WebUI.

Connecting to the Smart-1 Appliances CLI

To connect to the command line interface of the Smart-1 Appliances, use one of these:
• The included serial console cable (DB9 DTE to RJ45), with terminal emulation
software, such as PuTTY (from Windows) or Minicom (from Unix/Linux).
Connection parameters for Smart-1 Appliances are: 9600bps, 8 bits, no parity, 1
stop bit (8N1), Flow Control - None.
• An SSH connection to the management interface (if SSHD is configured).
Smart-1 205/210 Appliances Getting Started Guide
Configuring Smart-1 Appliances
| 25