Wall Mount Installation; Flat Mounting; Angle Mounting (Left Side Mounting) - RISCO Group WL T312 Instrucciones De Instalación

Wall Mount Installation

:
Note
The installation knockouts numbering are marked
on the back plate.
1. Open Wireless WatchOUT front cover
(unlock C1, Figure 1).
2. Release internal base (unlock I1, Figure
2).
3. Select mounting installation as follows:

Flat Mounting:

Open knockouts on external base (Figure 3).
B1 - B4: Wall mounting knockouts
T1: Back tamper knockout
45° angle Mounting (Left side
mounting):
a. Open knockouts on external base
(Figure 3).
L1, L2: Left mounting knockouts
T3: Left tamper knockout
b. Remove tamper spring (Figure 4).
c. Replace tamper bracket (Item 1) with
supplied flat tamper bracket (Item 2).
Item 1
d. Insert Tamper lever B onto T6 and T3
and secure screw A (Figure 3).
4. Secure external base to the wall.
5. Insert tamper wires through internal base
(Figure 4).
6. Secure internal base to external base (lock
I1, Figure 2).
7. Close the front cover (Lock C1, Figure 1)
after wiring and setting DIP switches.
8. Walktest the detector.
Note:
For 45° right side installation use the equivalent units on the external base as follows:
Knockouts Description
Mounting Knockouts
Tamper spring knockouts
Tamper screw anchor
6
Figure 1
Figure 3
Tamper
Lever
Item 2
A
Figure 4
Left
L1, L2
T1,T3
T5
Installation Instructions
C1
T1
T3
L1
B1
B
W5
W6
W3
L2
B4
Figure 2
I1
T5
T6
T4
T2
R1
(not visible)
B2
W9
W2
R2
(not visible)
B3
Right
R1, R2
T2,T4
T6