Printer Set-Up - Uline H-5836 Manual Del Usuario

5. Press the ZERO key
6. Press the TARE key
shown on the display.
Cont
• – Continuously sends data to printer.
St 1
• – Sends data one time to printer when
indicator is stable.
St C
• – Sends data continuously to printer when
indicator is stable.
Pr1
• – Sends data one time to printer when the
ACC/TTL Print key
Pr2
• – Performs accumulation and sends data one
time to printer when the ACC/TTL Print key
is pressed.
Auto
• – Performs auto accumulation and auto print
when indicator is stable and returns to 0.
7. Press the ZERO key
8. Press the UNIT key
BAUD RATE
Baud rate is the RS-232 transmission speed. If using a
printer, both the printer and the scale must be set to the
same baud rate. At startup, the baud rate is set at 9,600.
Enter this menu to change the baud rate setting
1. Turn on the scale and press the PCS key
Pn
the self-test. will be shown on the display.
2. Press the G/N key
then the TARE key
display.
3. Press the TARE key
display.
4. Press the ZERO key
will be shown on the display.
5. Press the TARE key
display.
6. Press the ZERO key
PAGE 11 OF 36
SETUP MENU CONTINUED
to enter the sub menu.
until the desired setting is
is pressed.
to select the new setting.
twice to exit the menu.
during
, then the UNIT key
Po CHF
. will be shown on the
P1 com
until is shown on the
Mode
to enter the menu.
Baud
until is shown on the
to enter the sub menu.
7. Press the TARE key
is shown on the display.
600
•
1200
•
2400
•
4800
•
9600
•
8. Press the ZERO key
9. Press the UNIT key

PRINTER SET-UP

Enter this menu to select a printer.
1. Turn on the scale and press the PCS key
the self-test.
2. Press the G/N key, then the UNIT key
the TARE key
display.
3. Press the TARE key
display.
4. Press the ZERO key
will be shown on the display.
5. Press the TARE key
display.
6. Press the ZERO key
and
7. Press the TARE key
shown on the display.
tPUP
• – Ticket printer
LP-50
• – Label Printer
8. Press the ZERO key
9. Press the UNIT key
until the desired setting
to select the new setting.
twice to exit the menu.
Pn
will be shown on the display.
Po CHF
. will be shown on the
P1 com
until
to enter the menu.
Ptype
until
to enter the sub menu.
until the desired setting is
to select the new setting.
twice to exit the menu.
during
and then
is shown on the
Mode
is shown on the
0621 IH-5836