EDM Product 07181 Manual Del Usuario página 19

07181
REF.
6- Setting the time and day using the control panel:
Using the M button, the time and day of week can be entered so that you can use the timer function. The
item should be ON, but should NOT heat and therefore, there is no heating symbol visible on the display.
(Do this by setting the temperature lower than the ambient temperature, for example.)
Step Press button:
1 M
2
+ or -
3 M
4 + or -
5 M
6
+ or -
7 M
8 Day and time are set
7- Setting the time and day using the remote control:
First, the day of the week and time should be entered in order to be able to use the timer function.
The item should be ON, but should NOT heat and therefore,there is no heating symbol visible on the display.
(Do this by setting the temperature lower than the ambient temperature,for example.)
Step Press button:
1
SET (3 sec.)
2 + or -
3 SET
4 + or -
5
SET
6 + or -
7 SET
8 Day and time are set
8- Setting the week timer using the remote control:
Attention 1: If the item is switched OFF using the main switch or by removing the plug from the socket, the
day will be set to 1 and the time to 00.00 the next time you switch the item ON again.
However, the timer data that were entered previously (ON and OFF times of the week timer) are stored. To
avoid misunderstandings, the week timer is automatically set to OFF in case of turning the heater off using
the main switch or removing the plug from the socket. Otherwise, the panel would switch on and off at the
wrong times. Switching the week times on again is described below.
Attention 2: If in the time setting mode no button is pressed for ten (10) seconds, the timer-setting mode
will stop and you will have to start all over again.
Attention 3: All timer settings - maximum 28 settings: seven (7) days multiplied by maximum four (4)
settings per day - are processed consecutively. Therefore, make sure that they do NOT contain contradic-
tions.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
The display shows:
HH flashes
1 to 7
H1 flashes
1 to 24
H2 flashes
1 to 60
Ambient temperature
The display shows:
HH flashes
1 to 7
H1 flashes
1 to 24
H2 flashes
1 to 60
Ambient temperature
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
Explanation:
Select day of the: 1 = Monday, 2 = Tuesday, etc.
Select the correct hour
Select the correct minute
Explanation:
Select day of the: 1 = Monday, 2 = Tuesday, etc.
Select the correct hour
Select the correct minute