EDM Product 07181 Manual Del Usuario página 21

07181
REF.
Attention (a):
The timer setting(s), which you make under 'once only (01)', should be made for the current week. On
Sunday (day 7) at 24.00, all 'once only' setting(s) are set to 'non- active'. Therefore, a timer setting for Satur-
day that you made on Tuesday will work, but a timer setting for Tuesday that you make on Saturday won't
work!
Attention (b):
If a timer setting with number 01 was made for this day, you must manually set the next timer setting for
this day to 02 using the + button, otherwise the timer setting 01 will be overwritten.
Attention (c):
Start & stop times can only be entered in whole hours (not in minutes).
9- Removal of timer settings using the remote control
Removing all timer settings
· Press the WEEK button for three (3) seconds, until the display shows the flashing UU.
· Pressing the C (Cancel) button will erase all timer settings.
Removing all timer settings of a specific day
· Press the WEEK button for three (3) seconds, until the display shows the flashing UU.
· Press the SET button and the display will show your flashing selection of ON/OFF (timer on or off).
· Press the SET button again and the display will show your flashing selection of 01/99 (only once or
endlessly).
· Press the SET button again and the display will show the flashing U1 (day 1).
· Using the + and/or - buttons, select the day for which you want to remove the timer settings.
· Pressing the C (Cancel) button will erase all timer settings of the day concerned.
Removing a specific timer setting:
· Press the WEEK button for three (3) seconds, until the display shows the flashing UU.
· Press the SET button and the display will show your flashing selection of ON/OFF (timer on or off).
· Press the SET button again and the display will show your flashing selection of 01/99 (only once or
endlessly).
· Press the SET button again and the display will show the flashing U1 (day 1).
· Using the + and/or – buttons, select the day for which you want to remove the timer settings.
· Pressing the C (Cancel) button will erase all timer settings of the day concerned.
10- Checking the timer settings using the remote control:
Press the WEEK button a few times briefly. You will see the following settings in sequence:
· Timer ON or Timer OFF
· Once only (01) or endlessly (99)
· U1-U7, day of the week
· Timer setting number of the day concerned (1, 2, 3 or 4)
· The set temperature of the thermostat
· Start time in hours
· Stop time in hours
This is repeated for the next timer settings.
All 28 timer settings are shown, also the timer settings that have not been filled. The temperature of the
non-filled timer settings is 45 °C.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
INSTRUCCIONES IMPORTANTES DE SEGURIDAD