Description Of Symbols; General Safety Warnings - Silverline 598501 Manual Del Usuario

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
WARNING: Moving parts can cause crush and cut injuries
Conforms to relevant legislation and safety standards
Specification
Pulling capacity:..................................................... 2000kg
Cable: .................................................................... 5.5mm x 3m
Ratchet system: ..................................................... Double
Leverage ratio: ....................................................... 15:1
Note: Pulling capacity is given as a rolling load on a level surface.
Exercise extreme caution and do not overload, particularly on
'deadweight' loads.
4

General Safety Warnings

WARNING Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in a
serious injury.
WARNING: This tool is not intended for use by persons
(including children) with reduced, physical or mental capabilities
or lack of experience or knowledge unless they have been given
supervision or instruction concerning use of the tool by a person
responsible for their safety. Children must be supervised to ensure that
they do not play with the tool.
Save all warnings and instructions for future reference.
1) Work area safety
a) Keep work area clean and well lit. Cluttered or dark areas invite
accidents.
b) Do not operate tools in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust.
c) Keep children and bystanders away while operating or using this
tool. Distractions can cause you to lose control.
2) Personal safety
a) Stay alert, watch what you are doing and use common sense
when operating or using this tool. Do not operate or use the
tool while you are tired or under the influence of drugs, alcohol
or medication. A moment of inattention while operating or using the tool
may result in serious personal injury. Work sensibly at all times with
regular breaks if necessary.
b) Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard
hat, or hearing protection used for appropriate conditions will reduce
personal injuries.
c) Remove any adjusting key or wrench before operating the tool.
A wrench or a key left attached to a rotating part of the tool may result in
personal injury.
d) Do not overreach. Keep proper footing and balance at all times.
This enables better control of the tool in unexpected situations.
e) Dress properly. Do not wear loose clothing or jewelry. Keep your
hair, clothing and gloves away from moving parts. Loose clothes,
jewelry or long hair can be caught in moving parts.
3) Tool use and care
IMPORTANT: Tools used outdoors may require more regular cleaning and
surface treatment to prevent corrosion, as well as replacement grease or oil
on moving parts to maintain them in good working condition.
a) Maintain tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect
the tool's operation. If damaged, have the tool repaired before use.
Many accidents are caused by poorly maintained tools.
b) Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
c) Use the tool's accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and
the work to be performed. Use of the tool for operations different from
those intended could result in a hazardous situation.
4) Service
a) Have your tool serviced or repaired by a qualified repair person
using only identical replacement parts. This will ensure that the
safety of the tool is maintained.