Publicidad
SLIDING DOOR HARDWARE - BY PASS
1
PREPARE OPENING
Hmax = Door Height + 4-1/8" • Hmin = Door Height + 3-3/8"
2-Door Width = 2 x Door Width - 1"
2
MOUNT FRAME HARDWARE
• Center tracks in opening flush
against each other.
• IMPORTANT: Place hangers loose
into track before securing.
• Using track as template, mark
screw locations.
• Drill 3/32" pilot holes and
secure with (# 10 x 1-1/2") screws.
Note: If necessary, track may be cut
with a fine tooth saw.
3
MOUNT DOOR HARDWARE
• Place door mount plate on top
of each door at the distance
shown from the outside edge.
• Using plates as a template,
drill 1/8" diameter holes for
mounting and one 3/8"
clearance hole 1-1/2" deep for
adjustment screw and secure
with (#12 x 1-1/4") screws.
• Mount pulls (not included).
Opening Width
Largeur d'ouverture
Anchura de la abertura
#310305_B (1112)
Instructions
Opening Height
Hauteur Ouverture
Altura Abertura
2-1/2"
(6,4 cm)
3/4"
(1,9 cm)
Assembly
3" - 3-3/4"
(7,6 cm - 9,5 cm)
Door Height
Hauteur Porte
Altura Puerta
3/16"
(0,5 cm)
Publicidad
