Mounting Your Chest Freezer - Aspes ACH1561 Manual De Instrucciones

PART 3
MOUNTING YOUR CHEST FREEZER AND FIRST START-UP
1.Remove the plastic transportation stiffener elements which have
been placed between the upper lid and the body.
2.It is compulsory to have an air circulation at the backside so as to
get a satisfying efficiency from the freezer. You should leave at least
20cm space at the sides of your chest freezer.
3.After mounting the freezer, expect at least for 2 hours without
moving before starting to use it. Then plug your device.
Line voltage and frequency must correspond to the values
written on the label located on the backside of the product. If
the line voltage is too lower or higher than the indicated
values, supply the desired voltage by assuredly using a voltage
regulator. You may consult a qualified electrician in regard to this
issue. The fuse of the wall-socket where your device is plugged must
be 16A maximum.
Climate Class Statement
Household type coolers and freezers have the climate classes as
indicated below according to EN62552 standard.
Climate Class
Class T
Class ST
Class N
Class SN
* Being a member of SN-T climate class, chest freezers that you have
purchased are designed to operate on average between 10
C.
Operating your device out of the anticipated ambient temperature
range may cause temperature decreases.
Acceptable ambient temperature
+16 C and 43
o
+16 C and 38
o
+16 C and 32
o
+10 C and 32
o
12
C
o
C
o
C
o
C
o
C and 43
o o