Cleaning And Maintenance - cecotec BREEZECARE 4000 CONNECTED Manual De Instrucciones

ENGLISH
Plug the device to a power supply. The display will light up and the device will beep. After 1
second, the display will turn off and the device will enter standby mode.
Press on/off, the device will start working under mist mode at level 2. The blue light indicator
will turn on. The control panel will display the current humidity.
Mist speed
While the display shows current humidity, press the Max./Min. button to check the current
mist speed. Press repeatedly to set the desired speed. There are 3 different settings.
Constant humidity
When the LED display is showing current humidity, press the Humidity symbol.
The humidity level can be set from 30 % RH to 90 % RH.
Every time the symbol is pressed, it will be increased by 5 %.
When it reaches 90 %, press again and the display will show "Co". Do not operate the device
for 3 seconds to cancel the humidity setting function.
Note: If the target humidity is higher than the current humidity, the humidification function
will work.
When the target humidity is lower than the current humidity, the device will enter standby
mode.
Note: The mist speed cannot be adjusted under constant humidity function.
During operation, hold down the humidity symbol for 2 seconds to turn the blue light
indicator and the display on. Touch the symbol again to turn it off. After 15 seconds of no
operation, the light indicators and display will turn off.
Timer
There are 12 timer settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,11, 12 hours.
Press the Timer symbol repeatedly to select the desired operating time.
Press the Timer symbol until "-- --" is displayed or hold down the Timer symbol twice to
cancel the timer.
Once the timer is set, do not touch any button and setting will be automatically saved after 5
seconds. After 1 minute, the display will show the current humidity.
The display will show the remaining time every hour.
Warm water mist
Press the Warm mist button to turn the warm mist function on and off. The warm mist
function indicator will light up.
Note: This function is not available when there is no water in the tank or when it is running
under a non-humidifying mode.
38 BREEZECARE 4000 CONNECTED
Auto shut-off system
When the tank runs out of water, the device will automatically stop operating. The empty
water indicator will turn on.
Refill the water tank, and the device will continue operating with the previous settings. If the
tank is not refilled, the device will turn off after 15 minutes.
Touch the light symbol to choose between the 3 different levels of blue light intensity. Tap 4
times to turn it off.
The device keeps the Wi-Fi connection activated during operation. To connect it, follow the
instructions on the App manual section.
In order to link your product with our App, please follow the below steps.
Download the BreezeCare App from Google Play or App Store.
If it is the first time you use it, register an account. If not, log in.
Once you have entered the App, press "+" on the top right-hand corner and tap "Breeze Care".
Turn your device on and hold down the power button for 5 seconds until the device beeps.
Check that the Wi-Fi icon is blinking.
Enter your Wi-Fi password and press confirm.
Then, the linking process will start automatically.
Warnings:
Never run the humidifier when there is no water in water the tank and water basin.
Do not pour any liquid other than clean water into the water tank or water base.

4. CLEANING AND MAINTENANCE

Use a soft, damp cloth to clean the surface of the device.
Do not use detergent, scouring pads, chemically treated cloths, gasoline, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water
leakage.
Do not immerse the product in water or any other liquid.
If scale is built up due to the use of hard water, it is recommended to:
Use cold boiled water or distilled water.
Clean the transducer, water tank and basin humidifier every week.
Change the water in water tank more often to keep it fresh.
Make sure to pour out water from the water tank and dry the water basin before you store it
unused for a long time.
Clean the whole humidifier and make sure that all parts of the humidifier are dried completely
ENGLISH
BREEZECARE 4000 CONNECTED 39