Smith Performance Sprayers S103EX Manual De Uso Y Cuidado página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Steps To Cleaning Your Sprayer
*** To prevent clogging issues, after each use clean your sprayer.***
WATER BASED PRODUCTS
1. Release pressure in your sprayer via pressure relief valve. Do not undo handle without removing pressure.
2. Empty remaining chemical back into original fi lling container.
3. Fill sprayer with water, place pump back into tank, and tighten.
4. Aggressively shake the water in the tank to try and get residue off of the inside walls of the sprayer. Repeat
step if necessary, each time refi lling with fresh water.
5. Pressurize the sprayer and spray water for 30-45 seconds into a disposable reservoir, then release pressure
and remove the pump from the tank.
6. Tip and empty tank, then set tank upright. Hold wand and shut-off above the tank and depress the
shut-off . The liquid will drain into the tank, empty again.
7. Repeat the steps above as necessary.
8. Allow tank to air dry by leaving the pump outside of tank over night.
Acetone Products
1. Release pressure in your sprayer via pressure relief valve. Do not undo handle without removing pressure.
2. Empty remaining chemical back into original fi lling container.
3. Add approximately one pint of acetone, place pump back into tank, and tighten.
4. Shake the liquid in the tank to try and get the residue off of the inside walls of the sprayer. Repeat step if
necessary, each time refi lling with fresh acetone.
5. Pressurize the sprayer and spray the acetone into an empty acetone can, then release the pressure and
remove the pump from the tank.
6. Tip the tank and empty any remaining acetone into the acetone can, then set the tank upright. Hold the
wand and shut-off above the tank and depress the shut-off . The liquid will drain into the tank, tip and
empty the tank once again.
7. Repeat the steps above as necessary.
8. Allow the tank to air dry by leaving the pump outside the tank overnight.
Sprayer Storage
1. Sprayer tank should be hung upside down, with the pump removed.
2. Do not store or leave any solution in the tank after use.
3. Store in a warm, dry location out of direct sunlight.
4. Keep the sprayer and all chemicals out of reach of children.
Pump Lubrication
Pump should be periodically oiled by applying 10 to
12 drops of light oil down the pump rod through the
opening in the pump cap as shown.
OPERATING INSTRUCTIONS CONTINUED
MAINTENANCE
Page 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

190468

Tabla de contenido