Pan Detection; Residual Heat Indication; Booster And Double Booster Function - Bertazzoni P786IM3B2NE Manual De Utilización

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work:
• If there is no pan on the heating zone or if this pan is not adapted to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a pan is put on the heating zone.
• If the pan is removed from the heating zone the operation is stopped. The display shows
[ U ]. The symbol [ U ] disappears when the pan is put back to the heating zone. The
cooking continues with the power level set before.
After use, switch the heat element off: don't let the pan detection [ U ] active.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster and double booster function

Power [ P ] and Super Power [
If this function is activated the heating zones work during 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big quantities of water, like nuddles
•
Start up / Stop the booster:
Action
Start up the booster
Stop the booster
•
Start up / Stop double booster
Action
Start up the booster
Start up double booster
Stop the double booster
Stop booster
•
Power management:
If the selected heating levels for both zones exceed the maximum available amount of power, the
power management function is automatically reducing the power from one of these zones. The
display of this zone is first blinking; the level is then automatically reduced to the highest suitable
position.
Heating zone selected
[ P ] is displayed
] grant a boost of Power to the selected heating zone.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Slide on the "SLIDER"
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Re-press key [ P ]
Slide on the "SLIDER"
Slide on the "SLIDER"
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
9
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]