Pan Detection; Residual Heat Indication; Booster And Double Booster Function - Bertazzoni Modern Serie Manual De Utilización

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work:
• If there is no pan on the heating zone or if this pan is not adapted to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a pan is put on the heating zone.
• If the pan is removed from the heating zone the operation is stopped. The display shows
[ U ]. The symbol [ U ] disappears when the pan is put back to the heating zone. The
cooking continues with the power level set before.
After use, switch the heat element off: don't let the pan detection [ U ] active.

Residual heat indication

After swittching off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on, don't touch the heating zones and don't put any heat
sensitive object on them. There are risks of burn and fire.

Booster and double booster function

The booster function [ B ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high power.
Power is foreseen for example to heat up rapidly big quantities of water, like nuddles
• Start up / Stop the booster Power function:
Action
Zone selection
Start up the booster
Stop the booster
•
Start up / Stop the super power function:
Action
Selection of the zone
Start up booster
Start up double booster
Stop the double booster
Stop booster
•
Power management:
The hole cooking hob is equipped by a maximum of power. When the booster function is
activated, and not to exceed the maximum power, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed:
Heating zone selected
[ P ] is displayed
Control panel
Press key [ 0 ] from the zone
Press key [ B ]
Slide on the "SLIDER"
Or press [ B ]
Control panel
Press key [ 0 ]
Press key [ B ]
Re-press key [ B ]
Press key [ B ]
Slide on the "SLIDER"
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
9
Display
[ 0 ] and control light on
[ P ] during 5 min
[ P ] to [ 0 ]
[ 9 ]
Display
[ 0 ]
[ P ]
[ and P ]
[ P ]
[ 9 ] to [ 0 ]
(example: power level 9)