0.5" in. Diameter
AA
Safety
Cable
9. Insert the ground wire from the electrical box into the wire connector attached to the green wire from the fixture body (B).
10. Reconnect the terminal and ground wires with the attached wire connectors.
11. Snap the lens cover (A) onto the fixture body (B).
12. Restore the power to the electrical box.
susPensIon MountIng
Mounting to drywall
1. Determine the position for the two toggles to be secured in the drywall mounting surface.
A. Drill two holes large enough to clear the closed flaps of the butterfly nut on the toggle bolt (not included). Make sure to
fasten the toggle bolt into the butterfly nut before inserting the flaps into the ceiling.
B. Tighten the toggle bolt.
Mounting to wood
2. Drill two 1/16 in. diameter holes in the ceiling to accommodate hook screws (not included). Make sure to fasten the combo
wood-machine end into the metal hook.
A. Tighten the hook screws (not included) into the wood.
B. Attach the S hook at the bottom of the mounting chain (BB) to the fixture body (B). Repeat this step on the other side of
the fixture.
3. Hang the fixture body (B) by placing one chain over each hook (not included) that has been installed on the ceiling.
4. Adjust chains to level light.
5. Feed the electrical wires from the electrical box through the appropriate conduit based on local electrical code and then
through a pipe clamp (not included) and through the open knock out hole in the fixture body (B).
6. Reattach the safety ropes to the fixture body (B).
7. Insert the hot and neutral (black and white) wires from the electrical box into the wire connectors of the same color wires
from the fixture body (B).
8. Insert the ground wire from the electrical box into the wire connector attached to the green wire from the fixture body (B).
9. Reconnect the terminals to the wire connectors.
10. Snap the lens cover (A) onto the fixture body (B).
11. Restore the power to the electrical box.
B
75" (1904 mm)
Keyholes
Wire Connectors
B
A