Safety Instructions - DesQ 20073 Informacion De Producto

Operation instruction
Attention! Risk for injury Risk for injury
Read Read the safety
instructions instructions to
before use! avoid electric
shock and/or
serious injuries!

SAFETY INSTRUCTIONS

Read the operating manual carefully before starting up the shredder!
- Ensure that the voltage and frequency of the power supply correspond to the data on the rating plate!
Incorrect voltage may result in destruction of the unit!
- The socket must be easily accessible
- Do not open the housing lid! This can cause serious injury like electric shock! The inner parts cannot be maintained.
- Repairs are to be effected by qualified after-sales service staff only, or else the warranty of this machine is no longer
valid. The safety devices must not be removed or manipulated.
INSTALLATION
1. Put the plug in a power socket.
2. This shredder has a built-in safety mechanism that requires the waste bin to be correctly inserted into the shredder.
Lining the waste bin with a plastic bag will interfere with this safety precaution and may keep the shredder from
functioning.
OPERATION
Remove all staples and paper clips! This will extend the shredders life. Max. capacity = 15 sheets at the same
time (80 grams)!
1. Press the ON/OFF button.
2. The shredder switches on automatically when a sheet of paper is fed into feed aperture. It stops once the sheet has
passed through.
3. Cd's should be inserted into the special CD entry slot. Do not press the REVERSE (REV) button when shredding a
CD, otherwise the shredder may be damaged. The shredder cannot shred paper and CD at the same time, and can
only shred one CD or creditcard at once.
4. When shredding small material like creditcards or receipts, insert them in the middle of the paper feed opening.
WHAT TO DO WHEN A PAPER JAM OCCURS
1. a. If the shredder fails because of a paper jam, press the REV button.
b. Toggle between FORWARD (FWD) and REV if jammed paper is not released by simply pressing REV.
When switching from FWD to REV, always stop momentarily to prevent possible damage to the motor.
2. Remove the rejected paper and feed less sheets into the shredder. Never pull paper out of the shredder, this will
damage the cutters.
3. Should it occur that the shredder does not react to anything then it is very likely that the motor is
overheated. Try the previous steps again after 30 to 40 minutes.
CAUTION !
1. a. This shredder is designed for short operation. If it runs for too long or overheats, the shredder switches off auto-
matically and must be cooling down for several minutes before it is ready to resume operation. 10 minutes on, 20 to
30 minutes off.
b. Do not exceed the maximum cutting capacity!
2. Keep hands and fingers away from the feed opening. Serious injury may result. Be careful with long hair and with
neck-ties, bracelets, and other jewellery.
3. Do not expose the shredder to rain or humidity
4. Do not operate the machine unsupervised
5. Always turn off the shredder by unplugging the machine before moving or cleaning. Cleaning only with a damp cloth!
6. Do not use in the vicinity of inflammable liquids or gasses. Do not use in the vicinity of corrosive materials.
7. Empty the basket and oil the shredder frequently for smooth, trouble free operation.
8. Never allow the shredder to remain in a jammed condition with the power turned on.
9. Do not alter the plug!
NOTE : The shredder is only suitable for shredding paper, CD and credit cards (not other materials like
labels, cardboard or plastics)! Never shred envelopes, labels or anything with glue or any sticky substance
as this will lead to paper jams.
Risk for injury
Do not reach into Pay attention
the paper feed that hair is not
with entering the
fingers or other paper feed.
body parts.
Risk for injury Danger of
electric shock
and damage
Children should Protect the
be supervised to appliance against
ensure that they moisture like
do not play with rain and humi-
the appliance. dity, keep aerosol
products away
Attention! Attention!
Ensure that Do not insert
clothing, ties, hair, paperclips
jewellery or other
small objects
are not in close
proximity to the
paper feed.