SPORTSTECH F37 Manual Del Usuario página 29

S2
S3
S2
STEP 1
Installing the upright frame
Upright and secure the upright frame into the stabilizer with Hex Bolt M8x50mm teeth 12mm (S2) and Hex
Bolt M8x16mm(S3) back sides.
Important: While assembly, it needs two persons to work together. One person holds the computer, and the
second tightens the bolts with the Allen Wrench (S1) provided.
ATTENTION: PLEASE ENSURE THAT THE SCREWS ARE TIGHTENED PROPERLY SO THAT THE THREAD IS
NOT DAMAGED.
EN
S3
S3
Abutting Joint
STEP 2
Installing the Computer
Connect the Signal Wire from the computer to the Signal Wire from the upright frame first . Then, secure the
computer into the upright frame with two Hex Bolt M8x16mm (S3) back sides. Tighten the bolts with the Allen
Wrench (S1) provided.
29