Publicidad
Idiomas disponibles
Idiomas disponibles
prevent potential negative consequences for the environment and
health, which could derive from improper treatment of the product.
For more detailed information on recycling this product, contact the
municipal office, the local waste disposal service or the shop where
it was purchased.
LIMITED WARRANTY:
Duration of warranty period: 1 or 2 years depending on customer
category in compliance with Directive 1999/44/EC.
For support service under warranty, please take the original purchase
ticket / sales receipt to the shop where the product was purchased.
The product will be repaired free of charge or immediately replaced
with similar product of equal or greater value.
13
ABSOLUTE FADE – Motor 3000 RPM
RECOMMENDATIONS FOR USE:
Before using the hair clipper the hair must be clean and dry. We recommend cutting small quantities of hair at a time, adjusting the
cutting length gradually until finding the one you want. The blades risk getting stuck if too fast movements are made or if a lot of hair is
cut at the same time. It can be used without attachment comb to trim beard, neck hair and sideburns.
BEFORE USING THE APPLIANCE:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO LUBRICATE THE
BLADE".
USE INSTRUCTIONS:
• Insert the desired attachment. This operation should always be done with the hair clipper turned off.
• Plug the appliance into the power outlet.
• Turn on the hair clipper by pressing the (O/I) button.
• Turn off the hair clipper by pressing the (O/I) button.
CUTTING LENGTH ADJUSTMENT:
The ABSOLUTE FADE hair clipper offers the possibility of making finishing touches with a height of 0.8 mm or 3.8 mm (if used without
any guide comb attached and using the blade cutting adjustment lever) and performing classic hair cuts with the following lengths: 1.5,
3, 4.5, 6, 10, 13, 19 and 25 mm.
ADJUSTABLE LEVER:
The lever for adjusting the blade cutting length is located on the left side of the body of the appliance; this lever lets you adjust the
cutting length to 0.8 mm if held towards the upper body of the appliance, or 3.8 mm if held towards the rear body of the appliance.
CLEANING AND MAINTENANCE:
A clean and properly lubricated hair clipper considerably improves its capacity and cutting precision.
14
Publicidad
