Acuity Brands Lithonia Lighting LBR468 FPAN Instrucciones De Instalación página 2

CAUTION: RISK OF PRODUCT DAMAGE
✓ Never connect components under load.
✓ Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
✓ Controls for dimming, auto-sensing, or remote control of a luminaire that are not factory-wired to the
luminaire must be checked for compatibility with the luminaire prior to installation. LED fixtures must be
powered directly off a switched circuit.
✓ Unless individual product specifications deem otherwise: Do not restrict fixture ventilation. Allow for some
volume of airspace around fixture. Avoid covering LED fixtures with insulation, foam, or other material that
will prevent convection or conduction cooling.
✓ Unless individual product specifications deem otherwise: Do not exceed fixtures maximum ambient
temperature.
✓ Only use fixture in its intended location.
✓ LED products are Polarity Sensitive. Ensure proper Polarity before installation.
✓ Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be worn
during all installation or servicing of the unit.
✓ Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
performance.
✓ Some components inside the fixture may not be serviceable. In the unlikely event your unit may require
service, stop using the unit immediately and contact an ABL representative for assistance.
✓ Always read the fixtures complete installation instructions prior to installation for any additional fixture
specific warnings.
✓ Always ensure that the electrical distribution system is up to NEC (and any applicable local code)
requirements.
✓ Verify that power distribution system has proper grounding. Lack of proper earth ground can lead to fixture
failure and may void warranty.
Choose either Part 15 OR Part 18 and move to Page 3 Installation Instructions under Delivery. Lithonia Outdoor will always use Part 15.
All luminaires that contain electronic devices that generate frequencies above 9kHz from any component within the luminaire comply with Part 15
of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation
This device complies with Part 18 of the FCC Rules but may cause interference with cordless and cell phones, radios, televisions, and other
electronic devices. To correct the problem, move the device away from the luminaire or plug into a different outlet. This product may cause
interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or
communications equipment operating between 0.45-30MHz.
Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and
Our Brands Indoor/Outdoor
Lithonia Lighting
Carandini
Holophane
RELOC
Light Concepts
Acuity Brands Lighting, Inc. assumes no responsibility for claims arising out of improper or careless installation or handling of its products.
ABL LED General Warnings, Form No. 503.203 © 2010, 2016 Acuity Brands Lighting, Inc. All rights reserved. 12/01/10
Conditions, please visit www.acuitybrands.com.
Indoor Lighting Outdoor Lighting
Aculux American Electric Lighting
Gotham Antique Street Lamps
Indy Hydrel
Juno Tersen
Mark Architectural Lighting
Peerless
Renaissance Lighting
Winona Lighting
Lithonia Lighting
1400 Lester Road Conyers Georgia 30012
P 800 315 4982 F 770 860 3129
www.Lithonia.com
Controls Daylighting
DARK TO LIGHT SunOptics
LC&D
ROAM
Sensor Switch
Synergy
© Acuity Brands Lighting, Inc. 2015
912-00158-001 Rev. B
Page 2
.
All Rights Reserved