English; Using The Attachments - Braun creation 2 C 1800 V3 Manual Del Usuario

English

Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
• Plug your hairdryer into an alternating current (Ù)
outlet only and be sure that your household
voltage corresponds to the voltage marked on
the hairdryer.
This appliance must never be used near
•
water (e.g. a filled wash basin, bathtub or
shower). Do not allow the appliance to
become wet.
• When using the hairdryer in a bathroom, always
unplug it after use. Even a switched-off hairdryer
presents a hazard if not unplugged.
• For additional protection, it is advisable to install
a residual current device (RCD) with a rated
residual operating current not exceeding 30 mA
in the electrical circuit of your bathroom. Ask
your installer for advice.
• Care should be taken not to block the inlet and
outlet grill when the hairdryer is switched on.
If either grill becomes blocked, the hairdryer will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
• Do not wrap the mains cord around the
appliance. Regularly check the mains cord for
wear or damage, particularly where it enters the
product and the plug. If you have any doubt
about its condition take the appliance to your
nearest Braun Service Centre for checking/
repair. The mains cord of the appliance may only
be replaced by an authorised Braun Service
Centre. Unqualified repair work can lead to
extreme hazards for the user.
Description
1
Switch
2
Cold shot button
3
Protection filter
4
Concentrator nozzle
5
Adapter
6
Volume attachment
7
Brush attachment
8
Straightening comb attachment
1
Switch settings
0 off
1 gentle drying
2 fast drying
1 styling
1-2
3
3
2
Cold shot
To fix a style with cold air, press the cold shot button.
3
Protection filter
Regularly wipe the filter clean. For a thorough
cleaning, remove the filter and clean it under
running water.
Concentrator nozzle
For precise styling use the concentrator nozzle.

Using the attachments

1 Attaching the adapter (a)
• Align the markings, attach the adapter
to the hairdryer and turn it clockwise until
it snaps into place.
• To remove the adapter, turn it anti-clockwise
and pull it off.
2 Connecting / changing the attachments (b)
• Choose an attachment (volume attachment,
brush attachment or straightening comb
attachment).
• Slide the attachment onto the adapter upwards
or downwards along the guiding grooves.
• To remove it, pull off the attachment upwards or
downwards.
3 Use
• For long-lasting styling results we recommend
that you apply a styling product (e.g. mousse)
and use the hairdryer on a low switch setting.
3.1 Volume attachment
• Using the volume attachment
volume and root lift to your hair.
• Place the volume attachment with the fingers
against your head.
• Gently move the attachment back and forth
over a small section until the hair moves up the
fingers. Hold the attachment in place until the
hair gets dry. Continue section by section.
3.2 Brush attachment
• The brush attachment
slightly shaping and brushing your hair while
drying, thus leaving your hair smoother and
shinier.
3.3 Straightening comb attachment
• The straightening comb attachment
for untangling, combing and straightening
mid-length to long hair.
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
Please do not dispose of the product in the
household waste at the end of its useful life.
Disposal can take place at Braun Service
Centre or at appropriate collection points provided
in your country.
4
6
, you can add
7
is ideal for untangling,
8
is ideal
5