EN
OPERATION
REMOVE DE INK PAIL
When the amount of the remaining ink in the pail is ending, the pump
starts to work very quickly. Stop your work immediately closing the
pump air inlet (pos. 4) (fig. 10). Remember that the lifter is still connec-
ted to the air inlet pressure.
To prevent contamination of the pump and the follower plate, the pail
should be removed only when a fresh drum is ready to be use.
To remove the pail:
•
Switch the lifter control (pos. 1) to "up" Position (fig. 10).
•
Press vacuum released valve so that air can enter underneath the
follower plate to allow it to rise (fig. 11).
•
Open the pail fasteners (fig. 12).
•
Replace the pail following previous instructions (fig.12).
Fig. 11
6
854 804 R. 03/20
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
!
CAUTION: The pump may have sudden movements during the
escape from the stem. Keep away from moving parts.
Fig. 12