Publicidad
Idiomas disponibles
Idiomas disponibles
Description: this device can be installed on board of any vehicle without modifying the electric system of it and it
operates in serial with the vehicle high beam headlights flashing. This device can control up to 3 different
operators (i.e. sliding gates + garage doors + garden lights) according to how many times your high beam
headlights will flash; see below schema.
Technical data of the device:
Power
Frequency
Absorbed power
Channels
Coding system
IP
Range
Installation tips: this device must be installed from qualified and professional installers and far from heat sources
and it has to be carefully secured at the vehicle structure and positioned in a place where it can not move with
vehicle vibrations. In order to get the best range, place the wire of the antenna pointing the front of the vehicle
How to install the device:
Remove from your vehicle the protection fuse of your left OR right high beam headlights (just one of two) using the
nipper (see vehicle manual as in the example):
After the original vehicle fuse has been removed, take the fuses holder delivered by DASPI and plug in the original
vehicle fuse and the 2A fuse remote control DASPI as shown in the picture (RESPECT POSITION)
WARNING: Plug in vehicle
high beam headlights fuse
in this position
Plug in the fuses holder
back where the high
beam headlights
protection fuse was
pluged in before
englIsH
WARNING: Plug in 2A
Daspi remote control fuse
in this position
RED
Aerial
+
12-14Vdc
433,92Mhz
15mA
3
Rolling code
65
min. 50mt up to 150mt
Wire at the negative of the vehicle
battery or at any vehicle metallic part
-
BLACK
Publicidad
