Remote Control - LiftMaster MyQ 889LM Manual De Instrucciones

PROGRAMMING

REMOTE CONTROL

1. Press the MyQ Control Panel LEARN
2. Press the button on the remote control
3. The garage door opener lights will flash
MyQ ENABLED
ACCESSORIES
1. Press the MyQ Control Panel LEARN
button twice, the red learn LED will
turn on.
2. Press the LEARN button on the MyQ
device.*
LEARN
Button
Model 825LM - Remote Light Control
Light module can be synchronized with the
garage door opener light bulbs.
LIFTMASTER INTERNET GATEWAY (NOT PROVIDED)
®
The LiftMaster Internet Gateway gives you control of your garage door from your internet
connected computer or mobile device.
To program your MyQ Control Panel to the LiftMaster Internet Gateway:
1. Download the MyQ App.
2. Set up an account and connect.
3. Select "Internet Gateway" and follow the instructions in the app.
IMPORTANT: When instructed to press the "Learn" Button this will be located on the MyQ
Control Panel and the "Learn" button must be pressed 2 times.
For more information on connecting your garage door opener, visit
LiftMaster.com/Customer-Support.
button twice, the red learn LED will turn
on.
that you wish to operate your garage
door.
(or two clicks will be heard) when the
code has been programmed.
Model 829LM - Garage Door and Gate Monitor
Indicates the status of your garage door from inside
the home and allows you to close an open garage door
from inside the house.
KEYLESS ENTRY
1. Press the MyQ Control Panel LEARN button twice, the red learn LED
will turn on.
2. Enter a 4-digit personal identification number (PIN) of your choice
on the keyless entry keypad. Then press the ENTER button.
3. The garage door opener lights will flash (or two clicks will be heard)
when the code has been programmed.
Command
LED (yellow)
Learn
LED
(Red)
LEARN
Button
2
? ? ?
PIN
Model 823LM - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
* MyQ accessories may be programmed to the
LiftMaster Internet Gateway (Model 828LM) or the
®
MyQ control panel. For instructions on programming
to the internet gateway refer to the manual.
?
LEARN
Button