Maintenance; Components; Ordering Information; Spare Parts - HC SWIFTPET+ Manual Del Usuario

Note:
Charging shall not be interrupted. If the charging process is interrupted, the next
charging may take place after the battery has been completely discharged.
In order to prolong the life span of a rechargeable battery the following rules should be fol-
lowed:
1. Before the pipetting aid is activated for the first time the battery should be charged.
2. SWIFTPET + should not be left uncharged for a longer period of time.
3. If the SWIFTPET + is left unused charge cycles should be performed every six months.

9 - MAINTENANCE

Cleaning
The SWIFTPET + does not require any maintenance. The external parts of the pipetting aid
may be cleaned with a swab moistened with isopropyl alcohol.
The nosepiece and the pipette holder with the check valve may be autoclaved at 121 °C
for 20 minutes. After autoclaving and cooling of the pipette holder bend it and squeeze it
several times in the area of the safety valve. The filters included in the set may be sterilised
by autoclaving at 121 °C for not more than 15 minutes.
Storage
The SWIFTPET + shall be stored in a dry place. The allowable storage temperature: -20 °C
to +50 °C.
During breaks in the work the pipetting aid shall be placed in the wall hanger included with
the pipetting aid.
The pipetting hanger may be fitted on a wall on a hook or stuck with the adhesive tape
attached to the hanger. The surface for the hanger should be smooth, clean and
degreased. After cleaning the surface, it should be wiped with isopropyl alcohol and left to
dry. Before sticking the pipetting hanger remove the protective film from the tapes attached
to the hanger. The hanger should be stuck by pressing it hard to the surface and by leaving
it attached without any load for a period of 24 hours.
Note:
Do not store the pipetting aid with a filled pipette.
7

10 - COMPONENTS

The SWIFTPET + set is supplied with the following components:
• Pipetting aid
• Charger
• Pipetting hanger
• Charging stand
• Membranefilter 0.2 μm
• Instruction manual

11 - ORDERING INFORMATION

The following versions of the SWIFTPET + differ with the type of included charger, depend-
ing on the mains voltage.
Versions Voltage
Continental Europe 230 V / 50 Hz
USA 120 V / 60 Hz
UK/Ireland 230 V / 50 Hz
Australia 240 V / 50 Hz

12 - SPARE PARTS

Item
Part name
in fig. 1
F Nosepiece
G Pipette holder
H Membranefilter 0.2 μm
Membranefilter 0.45 μm
K Connector gasket
L Continental Europe 230 V / 50 Hz
USA 120 V / 60 Hz
Charger 9V: UK/Ireland 230 V / 50 Hz
Australia 240 V / 50 Hz
M Charging stand
All rights reserved. Product described in this manual is subject to availability and technical modification. Errors excepted.
PZ HTL S.A. reserves the right to improve, enhance or otherwise modify its products without prior notification.
© 2010 PZ HTL S.A.
ENGLISH
Catalogue number
0351
0352
0353
0354
Number of
Catalogue no.
pieces in pack
9022 1
9021 1
9023 1
9024 1
9025 1
29025 1
9016 1
9017 1
9018 1
5410 1
8