Pulpdent Embrace WetBond Instrucciones De Uso

PULPDENT
Embrace bonds chemically and micromechanically to slightly moist teeth. It is tooth
integrating and margin-free, providing an exceptional seal against microleakage.
ALWAYS APPLY EMBRACE TO A SLIGHTLY MOIST TOOTH SURFACE.
QUICK REFERENCE GUIDE
INSTRUCTIONS FOR USE
Slightly moist surfaces exhibit neither dryness nor pooling of water. Lightly dry and remove excess water with com-
pressed air or a cotton pellet. Surfaces should be shiny or glossy. Overly wet surfaces will result in decreased
bond strength.
1. Thoroughly clean enamel surfaces with oil-free cleaning paste.
2. Rinse well, removing all residual paste from pits and fissures.
3. Prepare questionable enamel in the usual manner.
4. Isolate treatment area and dry lightly with oil-free compressed air.
5. Apply Etch-Rite 38% phosphoric acid etching gel to the clean tooth surface for
15 seconds. Rinse well. Do not disturb this surface.
6. Lightly dry and remove excess water with a cotton pellet or clean compressed air. LEAVE TOOTH
SURFACES SLIGHTLY MOIST. Moist surfaces should appear shiny or glossy. Overly wet surfaces will result
in reduced bond strength.
7. Embrace bonds to surfaces slightly moist from saliva; however, it is best to avoid bacterial contamination.
8. Place a 22-gauge or 23-gauge applicator tip securely on Embrace syringe and carefully start flow of sealant.
Use a new applicator tip for each patient. Recap syringe after use.
9. Apply Embrace to the prepared tooth surface. For pit and fissure sealing, flow
the material from cusp to cusp, but do not cover the marginal ridges.
10. Light cure. Cures with all lights. Curing time for a halogen light with a minimum
of 300 mW/cm is 20 seconds. More powerful lights will cure faster.
2
Note: Apply disposable barrier sleeves/wraps over multiple-use dental dispensers before use
with each patient. For additional information, refer to: http://www.fda.gov/MedicalDevices/
ProductsandMedicalProcedures/DentalProducts/ucm404472.htm
1
1. Clean, isolate and etch tooth for 15
seconds. Rinse well. Lightly dry. LEAVE TOOTH SURFACE
SLIGHTLY MOIST.
2. Apply Embrace sealant on slightly moist occlusal surface.
3. Light cure. Embrace cures with all lights.
PULPDENT Corporation
80 Oakland Street • Watertown, MA 02472 • U.S.A.
(617) 926-6666 or (800) 343-4342 • Fax (617) 926-6262
www.pulpdent.com • pulpdent@pulpdent.com
XP-EMS-IN-10w
REV: 12/2015