Front Wheel Assembly; Rear Wheel Assembly - first years Indigo Manual De Instrucciones

Section 4 - Stroller Assembly Continued

2. Front Wheel Assembly:

A. Locate a front wheel assembly and push the red
button 1 on top and firmly push on the wheel
assembly until it 'clicks' . Repeat for the
2
other side.
NOTE:Pull down on each wheel to ensure it is
attached.
B. To remove the front wheel assembly, push the
red button on top of the front wheel assembly
and pull off the front wheel assembly.

3. Rear Wheel Assembly:

A. Locate a rear wheel assembly. Push in the button
and slide rear wheel assembly pin into the rear
wheel housing 2 . Repeat for the other side.
NOTE:Pull out on each wheel to ensure it is
attached.
B. To remove the rear wheel assembly, push the
button 1 and pull off the rear wheel
assembly .
2
7
4. Canopy Assembly:
1
2
1
1
2
5. Bumper Bar Assembly:
2
1
Section 4 - Stroller Assembly Continued
A. Position stroller seat on the ground as shown.
Attach canopy clips to seat on both sides.
B. Attach hook and loop fasteners on each side of
canopy to the seat.
C. To remove the canopy, rotate c-clip and pull.
Detach the hook and loop fasteners.
A. To attach bumper bar, align ends on bumper
bar and push into holes until it clicks.
NOTE: Pull up on each side of bumper bar
to ensure it is attached.
1
B. To remove bumper bar, push button
bumper bar and pull 2 to remove.
to release
2
1
8