first years Indigo Manual De Instrucciones página 9

Section 5 - Stroller Operation and Use - Continued
10. To attach the Chicco infant car seat:
A. To remove the toddler seat from the stroller frame,
slide release buttons and lift off seat
1
from the frame.
B. Locate the infant car seat adapter and rotate
arms until they lock into place.
Note: To fold up infant car seat adapter, push release
button 1 and rotate arm 2 up.
Repeat for other side.
C. Lower the infant car seat adapter onto the hinges
until it clicks. Infant car seat adapter can be installed
forward or rear facing.
Note: Pull up on the infant car seat adapter to
ensure it is attached.
To remove infant car seat adapter
1
Pull on release tab and pull up adapter
15
2
2
1
2
1
2
.
2
1
Section 5 - Stroller Operation and Use - Continued
D. Lower the Chicco infant car seat into the infant car
seat adapter until it clicks.
Note: Pull up on the Chicco infant car seat to
ensure it is attached.
E. Route buckle webbing through the belt path on
1
both sides of the infant car seat
buckle . Tighten strap so that the infant car
2 3
seat is held tightly.
11. To remove the Graco infant car seat:
A. Unbuckle the webbing strap over the infant car
1
seat. Pull release handle on back of infant
car seat. Pull up on infant car seat
remove.
WARNING
Use only the following Chicco infant car seats with the infant
car seat adapter:
• Chicco KeyFit
™
• Chicco KeyFit 30
™
3
. Attach the
2
1
2
to
2
16
1