Assembling And Dismantling The Appliance - Zen & Pur KALY Guia Del Usuario

A S S E M B L I N G A N D D I S M A N T L I N G T H E A P P L I A N C E
Before you begin to assemble or disassemble the appliance, make sure the motor unit
unplugged from the wall outlet and the rotating parts are not in motion.
All the information below also applies to the container
Assembling and dismantling the blending container
Turn blending container
Place the blade unit A2 against the neck of container
Screw the blade unit A2 onto the neck of container
Put food and liquids into container
Attaching and removing the blending container from the motor unit
Place the motor unit A3 on a flat, dry surface, such as a kitchen counter. Onto the motor unit
blending container so that the arrow indicator on the blade unit
A3. Turn the blending unit clockwise until it attaches firmly to the motor unit A3. If the blending container
assembly is correctly attached to the motor unit A3, it cannot be lifted separately.
To remove the blending container from the motor unit A3, proceed in the opposite sequence.
To assemble the drinking bottle, screw the lid
A6. When carrying, make sure the spout is properly closed, so that the bottle's contents do not spill.
A7
1
1.1
A1, A9 ou A10 so that its neck points upward.
1.2
A1, A9 ou
A1, A9 ou A10. Turn the assembled container with the blade
unit A2 pointing downward.
N O T E
A1, A9 ou A10 before you attach the blade unit
1.3
To dismantle, proceed in the opposite order.
2
2.1
2.2
3
Assembling the drinking bottle
A6 onto the neck of bottle
A3
used for grinding and its set of blades A8.
A10 so that the blades point into
A2 lines up with the arrow on the motor unit
A1, A9 ou A10. Firmly tighten the lid
is turned off and
A1, A9 ou A10.
A2 to it.
A3 place the
25