Publicidad
Idiomas disponibles
Idiomas disponibles
E.
Strobe Power Supply Replacement.
High voltages are present inside the lightbar. Wait at least ten (10) minutes,
after shutting off power, before servicing this unit. Failure to do so may result
in property damage, serious injury, or death to you or others.
Disconnect ALL power to the lightbar before any maintenance is performed.
Other than the fuse, the strobe light power supply does not contain any user serviceable
parts. Should a breakdown in the power supply occur, it should be returned to Federal for repair
and replaced. To remove the power supply, proceed as follows:
1.
Remove the four #8 screws and lock washers which secure the power supply and
mirror bracket.
2.
Unplug the connectors from the power supply.
3.
Install the new power supply by performing the previous steps in reverse order.
WARNING
-5-
Publicidad
