EarthQuake 34098-REV2 Manual De Instrucciones página 5

Idiomas disponibles

Lift the log splitter from the wedge end and insert the rear legs (1 & 2) making sure the letters on the decals match and the

decals align as in figures 2 and 3.

Using two of the M10 bolts (11), M10 flat washer (16) and M10 spring lock washer (17), install the cross beam (6) between

the rear legs (1 & 2). The hardware should be loose installed. Cross beam (6) is identified by the decal referencing a lifting

location for the log splitter for transport.

Lift the pump end and insert the front legs (3 & 4) making sure the decals are aligned.

Fig. 2

Fig. 4

Fig. 6

Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST

5-TON ELECTRIC LOG SPLITTER STAND AND TRAY

Assembly Instructions

Fig. 3

Fig. 5

Fig. 7

Tabla de Contenido