EarthQuake 34098-REV2 Manual De Instrucciones página 6

Using two of the M10 bolts (11), M10 flat washers (16) and M10 spring lock washer (17), install the cross beam (7) between
4
the front legs (3 & 4). The hardware should be loose installed.
After installing legs look at the unit from a side view. It should look similar to figure 10.
5
Using M6 bolts (14, 22, 23), fasten to central rod (5) as shown in figure 11. At this stage the bolts should not be protruding
6
out of the weld nuts, as shown in figure 12.
6 Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
5-TON ELECTRIC LOG SPLITTER STAND AND TRAY
Fig. 8
Fig. 10
Fig. 11
Assembly Instructions
Fig. 9
Fig. 12