Zodiac 7004.N Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
4 . Press pusher A to stop and the final time is displayed .
5 . To reset the three chronograph hands to zero positioning, press
pusher B .
Adjusting the chronograph hands to zero position
1 . Pull crown out to position III (all three chronograph hands are in
their correct or incorrect zero position) .
2 . Keep pushers A and B depressed simultaneously for at least 2
seconds (the center stop-second rotates by 360° - corrective mode
is activated) .
3 . Press pusher A to single step the center stop-second hand . Press
and hold pusher A to advance the center stop-second hand quickly .
Press pusher B to advance to the next hand .
4 . Press pusher A to single step the hour counter hand . Press and
hold pusher A to advance the hour counter hand quickly . Press
pusher B to advance to the next hand .
5 . Press pusher A to single step the minute counter hand . Press and
hold pusher A to advance the minute counter hand quickly .
6 . Return the crown to position I .
All manuals and user guides at all-guides.com
12
Tachymeter Usage
The Tachymeter function is used to measure the rate of speed of
an object over a fixed distance . The scale, located either on the top
ring or the inside bezel of the timepiece, will display speed in Miles,
Knots, or Kilometers per hour .
Example of usage: In a driving race,
the car passes the first mile (km)
post when the seconds hand is at
the 12:00 position (60 second mark).
Commence measurement. At the
36 second mark the car passes the
second mile (km) post, you will see
that the car traveled a distance of
one mile at 100 miles (km) an hour.
Automatic Winding Movement
A timepiece fitted with an automatic winding movement obtains the
power to wind itself by the movement of your wrist . It is important
that your timepiece is adjusted to match the size of your wrist . A loose
fit may result in a loss in capacity of the timepiece to wind itself . When
fully wound, your timepiece has a power-reserve of approximately
42 hours . If the timepiece has not been worn for over 42 hours it is
advised that it be manually wound to ensure necessary power-reserve .
13

Publicidad

Tabla de contenido
loading

Tabla de contenido