Master TERA Manual De Uso Y Mantenimiento página 12

06.2 ROLLER SHUTTER WITH ANTI-LIFTING DEVICES AND WITHOUT STOPPER
Connect the power supply.
1-
Press PROG briefly (within 1 minute).
2-
The motor makes a signal
Press briefly UP.
3-
If the motor moves downward return to point 2,
if the motor moves upward go to point 4
Bring the roller shutter in an intermediate position,
4-
keeping pressed UP or DOWN.
Press STOP briefly 3 times and wait.
5-
The motor moves downward.
The motor stops automatically due to pressure on anti-lifting devices.
The motor moves upward.
Stop the motor in the desired position by pressing STOP.
6-
Press PROG briefly.
7-
If you want to make a fine adjustment of the limit switch press UP or DOWN
(motor moves in small steps)
Press PROG briefly.
8-
The motor signals DOWN-UP. End of the installation!!
ON
Prog
3x
Prog
Prog
04
Go to point 4
Repeat point 2
Only if fine adjustment is necessary