Icy Dock ToughArmor MB508SP-B ToughArmor MB508SP-B Manual De Instrucciones página 4

3-5
This device accommodates drives with up to
15mm height. Insert the 2.5" drive upside down
into the tray, be sure that the drive's connector
is located at the rear of the tray.
3-7
Insert the drive tray all the way back into
the device.
OPTIONAL: Installing Drive ID Plugs
To install drive ID plugs, gently twist off the
plug from the Drive ID Plugs mold and
insert it into the drive ID plug slot infront of
the tray.
1. Use a small plier to remove the plastic
cover on MiniSAS HD ports before
connecting the cables.
3-6
Use the included M3*4 screws to secure
the drive onto the tray, then flip the tray
back to the top side.
3-8
Close the drive tray latch to complete
drive installation.
Drive ID Plug
1
2
5
6
2. lnsert the device into external 2 x 5.25" bay
and use the included M3*2.5 screws to secure
the device. Connect the power & MiniSAS HD
cables to the device to finish installation.
M3*4 screw x 4
3
4
7
8