Tool Specific Safety Warnings; Additional Safety Rules For Grinders - JCB 18AG Instrucciones De Funcionamiento

TOOL SPECIFIC SAFETY WARNINGS

Wear ear protectors.
m
can cause hearing loss.
Wear eye protection.
m
to prevent eyes from exposure to flying
particles.
Wear dust mask.
m
measures against inhalation of dust. Some
materials can contain toxic materials. Also
work with dust/ chip extraction when
connectable.
Additional Safety Rules For
Grinders
This power tool is intended to
m
function as a grinder tool. Read
all safety warnings, instructions,
illustrations and specifications
provided with this power tool. Failure
to follow all instructions listed below may
result in electric shock, fire and/or serious
injury.
Operation such as polishing is not
m
recommended to be performed with
this power tools. Operation for which the
power tool was not designed may create a
hazard and casue personal injury.
Do not use accessories which
m
are not specifically designed
and recommended by the tool
manufacturer. Just because the accessory
can be attached to your power tool, it does
not assure safe operation.
JCB-18AG
Instruction & User Manual
Exposure to noise
Wear goggles
Take protective
The rated speed of the accessory
m
must be at least equal to the
maximum speed marked on the
power tool. Accessories running faster
than their rated speed can break and fly
apart.
The outside diameter and the
m
thickness of your accessory must be
within the capacity rating of your
power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
Threaded mounting of accessories
m
must match the grinder spindle
thread. For accessories mounted
by flanges, the arbour hole of the
accessory must fit the locating
diameter of the flange. Accessories that
do not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use a damaged accessory.
m
Before each use inspect the accessory
such as abrasive wheels for chips
and cracks, backing pad for cracks,
tear or excess wear, wire brush for
loose or cracked wires. If power tool
or accessory is dropped, inspect for
damage or install an undamaged
accessory. After inspecting and
installing an accessory, position
yourself and bystanders away from
the plane of the rotating accessory
and run the power tool at maximum
no-load speed for one minute.
Damaged accessories will normally break
apart during this test time.
7