Klarstein Antarctica Manual Del Usuario página 22

EN
22
Cleaning the surfaces of the unit
1. Clean the unit with a soft cloth and a neutral soap solution. Then rub it dry with a
soft cloth.
2. Stubborn stains can be removed with stainless steel wool. Do not use conventional
steel wool or sandpaper as this could scratch the surface of the unit.
Condenser maintenance
1. Clean the condenser regularly, otherwise ice production will decrease and the unit
may fail.
2. Clean the filter every 1-2 months with a neutral soapy water solution or detergent
and remove dust accumulations.
3. Clean the heat sink of the condenser from top to bottom with a soft brush. Make
sure that the heat sink is not bent.
4. If there is oil in the heat sink of the condenser, you can use a special cleaning agent.
5. The condenser should be replaced at least every six months and replace all
components correctly after cleaning.
Note: Make sure that the water supply is interrupted during cleaning and that the unit
is disconnected from the power supply.
Cleaning and disinfection of the ice container
Clean and disinfect the evaporator, ice grid, ice container and other equipment
components regularly to ensure that your equipment meets food requirements and
standards.