STACK-ON TS-20-MB-E-S Instrucciones página 4

SECURING THE SAFE
NOTE: e safe must be secured to the oor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: is safe must be mounted to the oor.
Failure to do so will compromise the safety and
security of the safe.
You must remove the safe from the skid/legs and
place the safe on the oor. Place the safe in the
desired location. When you open your safe, li the
bo om carpeting up to nd the two hole locations
marked on the oor insulation. Drill holes through
the insulation using the same diameter drill as the
diameter of the mounting hardware you are using.
IMPORTANT: e fasteners you use must
completely ll the hole you drilled into the
insulation. (Figure 1) You must use the fasteners
a er you drill the holes. Failure to do so will void the
re rating.
Use these holes to fasten the safe to the oor. Drill
the appropriate diameter and depth of pilot holes
into the oor depending on the type of hardware
being used and the type of oor surface. (Figure 2)
Secure the safe with the fasteners and replace the
carpeting.
1
2
TACTICAL GUN REST ASSEMBLY
Assemble the tactical gun rests in the center
compartment. You may want to elevate the guns on
a shelf as shown. Determine the height of the gun
rest and assemble to the brackets as shown.
Position the adjustable stock rest to support your
tactical guns as shown.
Slightly angle the barrel rest upward and hook the
tab into the wall bracket as shown.
Lower the gun rest so the back of the rest is ush
with the wall bracket. Secure the gun rest to the
wall bracket with one of the screws supplied.
4
21
40356-1409