Publicidad
Idiomas disponibles
Idiomas disponibles
Harness user's guide EVO iZi 1 & 2
electric arcs, etc.) or thermal stress
(hot surfaces, blowtorches, etc.).
- The fall arrest system must be
attached to the dorsal D ring or to
the sternal keepers. These points are
identified by letter A (single snap hook)
or A/2 (Attachment to connect with
each other).
- The use of the harness with a fall-
arrest subsystem must be compatible
with the instructions for use of each
component of the system and with the
standards: EN353-1 / EN353-2 / EN
355 / EN360 / EN 362. For mobile
fall-arrest systems including a rigid
(EN353-1) or flexible (EN353-2) belay
support, it is recommended to connect
the harness using the sternum anchor
points. For energy absorbers (EN355)
or self-retracting fall-arrest systems
(EN360), connect the harness to the
dorsal anchor point.
- The anchor point on the structure
used to fix the fall-arrest system must
be slightly above the user, and must
comply with the minimum resistance
requirements
specified
795:2012 standard (R ≥ 1200 DaN).
Try not to distance yourself too much
from this anchor point in order to limit
the impact of a possible pendulum fall.
- After a fall, the harness must be
destroyed.
- The use of the belt fitted with
connectors with screw gate locking
is accepted only if the user does not
have to lock or open the connector
too frequently that is to say several
times on the same working day. If this
is the case, it will be better to use a
connector with an automatic locking.
- A connector must never have a load
on its clasp.
GENERAL CONDITIONS OF USE
OF THE HARNESSES AND WORK
RESTRAINT BELTS :
- A periodic inspection carried out by
a competent inspector is necessary to
ensure the safety of the user, which
is connected to the maintenance of
the effectiveness and resistance of
the equipment. A mandatory annual
inspection will check the condition of
the equipment and it can only continue
to be used on obtaining a written
agreement.
- Do not expose these products to
temperatures less than -30°C or more
than 50°C.
- This equipment must not be used in
any way contrary to these specifications
and under no circumstances should its
limits be exceeded.
- Storage: the product must be stored
in
a
sheltered from any direct or indirect
source of heat and from ultra-violet
rays. Drying wet equipment must be
performed in the same conditions.
- Cleaning and disinfection: exclusively
with water and a neutral soap.
-
Packaging:
watertight protective packaging.
in
the
EN
- Transport: packaged and sheltered
from impacts or pressure caused by
the environment.
- The product must not be modified or
repaired.
- Service life: Fall-protection PPE are
designed to last for several years
in
normal
preservation. The service life depends
on the use. Certain environments that
are particularly aggressive, marine,
siliceous or chemical can reduce the
service life of PPE. In these cases,
special care must be taken regarding
protection and the inspections before
use. The mandatory annual inspection
will validate the correct functioning of
the mechanism and it can only continue
to be used on obtaining a written
12
dry
and
well-ventilated
use
rot-proof
conditions
of
area,
and
use
and
Publicidad
