Heater Assembly; Connecting Heater To Propane Tank; Operation; Operating Information - Dyna-Glo RMC-TT15 Manual De Mantenimiento, Operación E Instalación Del Usuario

Heater Assembly

(Dual burner models only)
The tank collar bracket must be assembled before the
heaters can be attached to the propane tank.
1. Align bolt holes in tank collar bracket and piezo
bracket with bolt holes in center plate on manifold.
2. Thread two machine screws into the bolt holes
attaching tank collar bracket and piezo bracket to
center plate on manifold. (Fig. 1)
3. Connect spark plug cable (left) and spark plug cable
(right) into each terminal of piezo lighter.
CAUTION: The spark plug cables have
different connectors. Be sure to connect
each spark plug into the correct terminal.
Make sure terminals are securely con-
nected.
Manifold
Spark Plug
Cable (Left)
Center Plate
Piezo Bracket
Tank Collar Bracket
RMC134
Fig. 1 Assemble tank collar bracket.

Connecting Heater to Propane Tank

Read and understand all safety information before
connecting heater to propane tank.
1. (Applies to dual burner models only). Place heater
onto tank with tank collar bracket over tank collar
(Fig. 1) Mounting bolt knob should be positioned to
the outside of tank collar.
2. (Applies to dual burner models only). Firmly secure
to tank by hand-tightening mounting bolt knob. Do
not overtighten mounting bolt knob.
3. Make sure heater regulator knob is in the "OFF"
position.
4. Wrench tighten the fuel connector nut into the
propane tank valve with both gas hose fittings in a
horizontal position. (Fig. 1) Turn fuel connector nut
counterclockwise to tighten. Threads are left-
handed.
4
Fuel
Connector
Nut
Spark Cable
(Right)
Heat
Regulator
Knob
Machine
Screw
Mounting Bolt
Knob
Propane
Tank
Valve
Heater
Regulator
Knob
RMC101
Fig. 2 Attach heater to tank with tank collar bracket.
5. Connect the hose to inlet connector. (Fig. 2) Tighten
firmly using wrench. Make sure hose is connected
before opening the tank valve.
6. Open propane tank valve slowly.
7. Check all fittings for leaks. Apply a mixture of liquid
soap and water to all joints. Bubbles forming show a
leak. Correct all leaks at once.
WARNING: Never use an open flame to
check for leaks.
8. Always remove propane tank from heater after each
use. Do not store heater while attached to propane
tank.

Operation

WARNING: Burner and Burner Guard
should always face away from propane
tank shut-off and regulator.
WARNING: Improper installation, alter-
ation, service or maintenance can cause
property damage, injury or death. Read
the installation, operating and mainte-
nance instructions thoroughly before
installing or servicing this equipment.

Operating Information

This is a propane, direct-fired, heater. Its intended use
is primarily temporary heating of buildings under
construction, alteration or repair.
WARNING: Not for home or recreational
vehicle use.
Inlet
Connector
Piezo
Mounting Bolt
Knob
Fuel Connecting Nut