Converting To Propane (Lp) Gas Or Converting Back To Natural Gas From Propane (Lp); Gas Supply - Design CAFE CGY366 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONVERTING TO PROPANE (LP)
4
GAS OR CONVERTING BACK
TO NATURAL GAS FROM
PROPANE (LP)
conversion must be performed by a qualified propane
(LP) gas installer.
The conversion orifices
and instructions can
be found on back of
the range.
Keep these
instructions and all
orifices in case you
to natural gas.
5

GAS SUPPLY

WARNING
check for gas leaks.
WARNING
Overtightening may damage the pressure regulator
Gas Pressure Regulator
You must use the gas pressure regulator supplied
Natural Gas:
Propane (LP) Gas:
If you are not sure about the inlet pressure contact
local gas supplier.
NOTE:
and should be installed at the rear of the range near
off valve is to be used in the
event that service is required.
remove the toe-kick panel
and reach under the range.
provided for connection to
the range gas inlet.
10
Installation
Cooktop Regulator
Oven
Propane
Regulator
Conversion Kit
Gas Inlet
5
GAS SUPPLY (cont.)
Shut off the main gas supply valve before
disconnecting the old range and leave it off until
the new hook-up has been completed. Don't
forget to relight the pilot on other gas appliances
when you turn the gas back on.
appliance connector is recommended unless local
codes require a hard-piped connection.
connection is made.
A. Install a manual shut-off valve in the gas line in an
easily accessed location outside of the range. Make
NPT internal thread at inlet of the shut-off valve on
valve to avoid damage.
taking care to back-up the shut-off valve to keep it
from turning.
adapter on the range. Position range to permit
connection at the house shut-off valve.
all range controls are in the off position and turn
on the main gas supply valve. Use a liquid leak
detector at all gas connections to check for leaks
in the system.
disconnect the range and individual shut-off valve
from the gas supply piping. When using pressures
system by closing the individual shut-off valve.
the inlet pressure must be at least 1" greater than the
operating (manifold) pressure as given on rating label
of product.
31-2000814 Rev. 1

Publicidad

Tabla de contenido
loading

Tabla de contenido