QEP 83200 Manual De Operación página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

83200 MANUAL-UPDATE_5377.qxd:83200 MANUAL-tri_3042.qxd
6. Adjust the balance screw on right leg (Fig 7).
7. To mount the handle position the handle on the
trolley and secure it using the 2 screws (Fig 8).
8. The motor trolley is secured during shipment,
please loosen knob before using (Fig 9).
FILLING THE WATER TRAY AND DRAINING
1. Fill the tray with water. Do not add chemicals or
detergents to the water.
2. Remove the plug from the bottom of the tray, the
water will flow out or you can remove the tray
and pour the water out (Fig 10).
MAKING A STRAIGHT CUT
1. Push the motor trolley away from the operator
until it reaches the stroke limit.
2. Position the tile on the cutting table.
3. Properly set the measuring guide and squaring
tool (Fig 11).
4. Adjust the guides as needed so that the tile rests
against the measuring guide and squaring
tool (Fig 12).
5. Pull the motor trolley slowly towards the material
to be cut (Fig 13).
6. When you have completed the cut push motor
trolley/blade away and remove the cut pieces, and
any debris on cutting surfaces.
MAKING A DIAGONAL CUT
1. Follow the same procedure for a straight cut.
2. Loosen the nut on the squaring tool, and position
the tile diagonally.
3. Lock the nut and perform the cut following
procedure for a straight cut.
ANGLED OR 45 DEGREE CUTS
1. Loosen the two knobs at either end of the
bridge (Fig 14).
2. Tilt bridge to the desired angle up to 45 degrees
(Fig 15). Tighten knobs at either end of bridge,
and proceed with cutting tile following same
procedure as listed in the "straight cut" section.
CHANGING THE BLADE
WARNING! Disconnect the power supply before making
adjustments, maintenance, cleaning or replacing the blade!
1. CHOICE OF THE SAW BLADE. Only use 8 Inch
continuous rim or turbo blades with a 5/8 Inch
arbor.
2. REPLACING THE SAW BLADE
A. First, press the blue rings on the water
hose connector and remove the water
tubes (Fig 16).
2/16/10
3:15 PM
Page 7
Figure 10
Figure 12
Figure 14
Figure 16
- 7 -
Figure 8
Figure 11
Figure 13
Figure 15
Figure 9

Publicidad

Tabla de contenido
loading

Tabla de contenido