Before First Use; Firmware Updates - WaterLink SpinTouchFF Manual De Instruccion

SETUP

BEFORE FIRST USE

¬ Fully charge battery using the Spin Touch USB cable and adapter plug in AC
outlet.
¬ Ensure your Spin Touch has latest firmware
1. Download and install WaterLink® Connect 2 Application for Windows
at http://softwarecenter.lamotte.com/. Select WaterLink® Connect 2
Software for Windows FREE Download.
2. Plug meter into the computer with the provided USB cable and launch
WaterLink
3. A prompt will appear if firmware updates are available. Select Update.
Testing and data transfer will not be possible until firmware has been
updated.
METER
1. The meter can be powered from an AC outlet, a computer or the internal battery.
2. Use the USB cable and the adapter to plug the meter into an AC outlet.
3. Use the USB cable to connect the meter to the USB port of a computer.
CHARGE THE BATTERY
1. Use the USB cable and the adapter to plug the meter into an AC outlet or use the
USB cable (included) with a car charger (not included) to charge the battery. (Anker
PowerDrive 2, DC 12/24V, 5V = 4.8A, Part Number A2310 recommended.)
2. The battery icon on the screen will show the battery status. Charge the battery until
the battery indicator is full.

FIRMWARE UPDATES

Occasionally, the firmware in the Spin Touch will require updates. To do so:
1. Visit http://softwarecenter.lamotte.com/
application for Windows.
2. Plug the Spin Touch into the computer using the included USB cable.
3. Open the WaterLink
complete.
Once the update is complete, it is safe to close WaterLink
After updating firmware it is recommended that the LED and Calibration Procedure on
page 20 be performed.
NOTE: When a prompt to update the firmware is received, the options Update Now or
Remind Me Later will be displayed. If Remind Me Later is chosen, the update prompt will
be displayed again in 23 hours. Or, to update the firmware at any time, open WaterLink
Connect 2, go to Settings>Service Settings>Get Updates.
PC CONNECTION
When the WaterLink
touchscreen becomes disabled and operation of the lab is performed using the WaterLink
Connect 2 application for Windows
softwarecenter.lamotte.com/. Via the WaterLink
from the Spin Touch can be transferred to a water analysis program such as WaterLink
Solutions .
™
Connect 2 Application from the Start Menu.
®
Connect 2 desktop application and wait for the update to
®
Spin Touch is connected to a computer via USB, the onboard
® ®
. This application is available for free at
®
and download the WaterLink
Connect 2 and unplug the lab.
®
Connect 2 desktop application, results
®
3
Connect 2
®
®
®
http://
®