Porter Cable POCKET CUTTER 552 Manual De Instrucciones página 13

Fig. 9
2. Position the screw through the access hole in the top of the cabinet (Fig. 9),
and into the hole in the motor mounting bracket. Hold the screw and wrench
in this position.
3. Position drill motor into the cabinet (Fig.
10), and secure in place with the mounting
screw.
4. Plug the drill motor power cord into the
receptacle (see Fig. 11).
5. Move the drill motor switch (A) Fig. 11 to
the "ON" position.
INSTALL THE POCKET CUTTING
MOTOR
1. Loosen motor clamp nut (A) Fig. 12. Use the 7/16" wrench to rotate the clamp
nut COUNTER-CLOCKWISE several turns to loosen the clamp.
2. Orient the motor as shown in Fig. 13, and insert it into the clamp. Seat the
motor into the mounting bracket. Make sure that the upper motor housing (A)
Fig. 14 touches the mounting bracket (B) Fig. 14.
Disconnect the tool from
the power source.
Disconnect the pocket cutting motor and the tool from
power source and place switches in the "OFF" position.
Fig. 10
13