Yakima 8880201 Manual De Instrucciones página 2

Perform steps 1 through 7 on each RailGrab tower.
Remove rubber pad.
Remove standard claw assembly, separate nut and knob.
Slide off the standard
claw assembly. (The
standard claw assembly
consists of a claw base,
a claw, a nut, and a knob)
Assemble pin adapter assembly, attach knob, install nut.
Slide the pin adapter into the short
claw base that was provided in this
kit. Orient parts as depicted above.
1033581A-2/9
short claw base
pin adapter
Remove claw tightener screw.
Turn standard claw
assembly upside
down and drop the
nut into your hand.
Set nut aside.
Reinstall the knob.
Open cover and remove the
black claw tightener screw
from your RailGrab tower.
Remove the knob from
standard claw assembly.
Set knob aside.
Install the nut into the
nut compartment as
shown.