Publicidad
Idiomas disponibles
Idiomas disponibles
Slide pin adapter assembly on.
Slide the pin adapter assembly
onto the RailGrab tower.
Replace rubber pad.
Replace the
rubber pad.
Make sure pad
is fully seated.
Adjust pin adapters to interface with factory rack.
Refer to steps three and four of your RailGrab
instructions to adjust the pin adapter (claw) vertically
and horizontally, but adjust so that the pins line up with
the mounting holes on your factory rails.
Once each set of bar and towers have the pin adapter
seated in the mounting holes, follow your RailGrab
instructions from step 6 completely through to the end
of the instruction.
CAUTION: All teeth
of pin adapter must
be fully engaged
with short upper
claw's teeth.
clearance installation. Use caution when choosing accessories for your rack.
1033581A-3/9
Installation of RailGrab rack system using pin adapters results in a low
Replace claw tightener screw.
Replace the claw tightener screw. Claw
tightener must engage with square nut.
claw tightener
square nut
Begin following your RailGrab instructions.
Follow steps 1 and 2 of your RailGrab
instructions to put your towers on your
crossbars, install the end caps, and
place them on your factory rails.
BE SURE TO USE THE SAME HOLE ON BOTH
DRIVER'S SIDE AND PASSENGER'S SIDE
RAIL TO ALIGN THE CROSSBARS EVENLY.
TIP: Use a towel on the
rooftop to avoid damaging
your vehicle's finish.
Publicidad
