Korg RK-100S 2 Manual Del Usuario página 12

RK-100S 2 Owner's Manual
Switching the octave with the OCTAVE
buttons
The pitch range assigned to the long ribbon controller
while playing the keyboard or scales can be changed in
one-octave increments over a range of ±3 octaves.
Keyboard
Press the -
and ribbon
button
range
↓ C6–C9
C5–C8
↓
C4–C7
↓
C3–C6
↓
C2–C5
↓
↓ C1–C4
↓ C0–C3
Simultaneously press the OCTAVE +/- buttons to return
to ±0.
Using the short ribbon controller
The short ribbon controller can be used to control the
pitch and modulation of sounds.
The parameter being controlled can be switched with the
SHORT RIBBON button.
Tip: The sound editor software (when the RK-100S 2 is
connected to a computer via USB) can be used to specify
whether pitch or modulation is controlled with the short
ribbon controller when the program is switched.
Controlling the pitch
2
1. Press the SHORT RIBBON button so that it is lit up in
red.
2. While playing the keyboard, use the short ribbon
controller.
Slide your finger to the left and right along the
ribbon controller. With the original pitch at the
center of the ribbon, raise and lower the pitch by
moving your finger in either direction. Removing
your finger from the ribbon will return the pitch to
the original setting.
12
Press the +
OCTAVE LED in the display
LED on right side lit up in red
LED on right side lit up in orange
LED on right side lit up in green
Dark
LED on left side lit up in green
LED on left side lit up in orange
LED on left side lit up in red
1
2
Original pitch
Applying modulation
1. Press the SHORT RIBBON button so that it is lit up
in green.
2. While playing the keyboard, use the short ribbon
controller.
Slide your finger to the left and right along the
ribbon controller. With the original sound at the
button
left end of the ribbon, apply modulation by moving
↑
your finger to the other end. Removing your finger
from the ribbon will return the sound to the original
↑
setting. Depending on the selected program, the
↑
vibrato depth will be varied or the tone will be
↑
modified by changing the cutoff frequency.
↑
↑
↑
Using the long ribbon controller
The long ribbon controller can be used to play scales and
to control the pitch and filter of sounds.
Tip: The tone, range of notes and direction in which the
effect is applied with the long ribbon controller differs
depending on the program. In addition, these settings
can be specified with the sound editor software (when the
RK-100S 2 is connected to a computer via USB).
Playing scales
Single notes of the previously specified scale can be
played.
2
1. With the LONG RIBBON PITCH/HOLD and FILTER/
HOLD buttons turned off, use the long ribbon
controller.
Slide your finger to the left and right along the
ribbon controller. The specified scale can be played.
The notes produced with the ribbon controller are
monophonic (single notes). In addition, higher
pitched notes (ribbon position) will take priority
when played.
Tip: The specified scale to be played can be changed with
the sound editor software (when the RK-100S 2 is connected
to a computer via USB).
2. The octave range can be switched with the OCTAVE
+/- buttons while playing.
1